DIY Beach Chair: Build Your Own Perfect Summer Companion
Materials and Tools You'll Need
Materials:
- 2x4 lumber: (4) 8-foot pieces for the legs, (4) 2-foot pieces for the top rails, (2) 12-foot pieces for the seat slats
- 1x4 lumber: (2) 12-foot pieces for the armrests
- 1/2-inch plywood: (1) 2-foot by 4-foot piece for the seat
- 1-inch wood screws
- 2-inch wood screws
- Wood glue
Tools:
- Circular saw or miter saw
- Drill
- Sander
- Measuring tape
- Pencil
- Clamps
Step-by-Step Instructions
1. Cut the Lumber
Cut the 2x4 lumber according to the materials list. The leg pieces should be 8 feet long, the top rails should be 2 feet long, and the seat slats should be 12 feet long.
2. Assemble the Legs
Lay two of the 8-foot pieces of 2x4 side by side, parallel to each other, and spaced 2 feet apart. Drill two 2-inch wood screws through the top of one leg into the side of the other leg. Repeat with the other two legs.
3. Attach the Top Rails
Position the two 2-foot pieces of 2x4 across the tops of the legs, flush with the outside edges. Secure them with 1-inch wood screws.
4. Attach the Seat Slats
Lay the 12-foot piece of 1/2-inch plywood on top of the legs, centered between them. Secure it with 1-inch wood screws, spaced evenly apart.
5. Attach the Armrests
Cut the 1x4 lumber into two 12-foot pieces. Position one piece along the front edge of the seat, flush with the outside edge. Secure it with 1-inch wood screws. Repeat with the other piece on the back edge of the seat.
6. Sand and Finish
Sand the entire chair to remove any splinters or rough edges. Apply a sealant or paint to protect the wood and enhance its appearance.
Conclusion
Enjoy your new DIY beach chair! It's perfect for relaxing on the sand, at the pool, or even in your own backyard.
Comments